Kullanım kılavuzu Revell set 24040 Tiger Radyo-kontrol helikopter

Kullanım kılavuzu

8

• After a crash, always move the actuating regulator right down immediately

• Do not subject the helicopter to direct sunlight or bright headlights whilst it is ying. This may lead to malfunction of the IR remote control unit.

• The infrared receiver on the helicopter and the infrared transmitter on the remote control unit must not be covered up. If the receiver or the transmitter are covered up,

the helicopter cannot receive any signals.

• Do not apply stickers or other labels to the helicopter as these might inuence the infrared signal transmission.

• Two or more helicopters of the same model cannot be own using the same band.







• Always lay the helicopter down on a smooth surface. A slanting surface may negatively affect

the starting characteristics of the helicopter.

• Always move the regulator slowly and sensitively.

• Always observe the helicopter and not the remote control unit!

•

Mo

ve the actuating regulator downwards slightly as soon as the helicopter lifts off from the

ground. In order to maintain the ying height, adapt the actuating regulator settings.

• If the helicopter goes lower, move the actuating regulator upwards slightly.

• If the helicopter rises, move the actuating regulator downwards slightly.

•

In or

der to y into a curve, it is often sufcient to tap the direction regulator gently into the

appropriate direction. During the rst ight attempts, people tend to control the helicopter too

vehemently. The control regulator should always be moved slowly and carefully - never quickly

or suddenly.

•

Beginners should, a

fter trimming, rst try to command the actuating regulator correctly. The

helicopter does not necessarily have to y straight ahead at rst - it is more important to main-

tain a consistent height of approximately one metre above the oor by repeated, brief tapping

of the actuating regulator. Only then should you practice moving the helicopter left and right.



The location in which the helicopter is own must full the following criteria:

1. It should be a closed room in which there are no strong draughts. If possible,

no air conditioning, heating fans etc. should be present which may generate air streams.

2. The room should be at least 10 m long, 6 m wide and 3 m high.

3. There should be no objects in the room (fans, lamps etc.) which might hinder ight.

4.

On s

tarting, you must ensure that all living creatures - including the pilot - are standing

at least 1-2 m away from the helicopter when the ight begins.

5.

Alw

ays observe the helicopter to ensure it does not y at the pilot, other people or animals

and injure them.



Since 2005, it has become obligatory to insure model aeroplanes and helicopters which can y

higher than 30 . Please discuss the matter with your personal liability insurance company and

make sure that your new and previous models are included in this insurance. Have this

conrmation set down in writing and store it safely.





Cause: • The ON/OFF switch is set to “OFF”.

• The battery is too low or empty.

• The helicopter is not ready.

• Set the ON/OFF switch to “ON”.

• Charge the battery.

• Set the actuating regulator to full and back to

zero and wait for 5 seconds.



Cause: • The battery is too low.

• The infrared connection is being disturbed

(e.g. excessively bright lighting).

 • Charge the battery.

• Secure the infrared connection; change the

location if necessary.





Cause: • Another infrared source is disturbing the

signal transmission.

• The signal transmission is disturbed due to

bright light irradiation.

• Avoid possible infrared disturbance sources

or switch them off.

• Use the helicopter in a different location.



controlled.

Cause: • Trimming too extreme to the right or left,

e.g. due to incorrect, permanent pressing on

the trim buttons

• Reset the trimming by repeated, brief taps

on the trim buttons for the opposite direction

(see Page 7)



own axis to the left or right.

You can nd further tips and tricks on the Internet at www.revell-control.de.



Up to three pilots can y their helicopters at the same time! To do this, proceed as follows:

• Pilot 1 switches their remote control unit on and selects channel A

•

Pilo

t 1 switches their helicopter on. Once it is ready, the pilot taps the actuating regulator briey,

whereby the helicopter sets itself to channel A.

• Pilot 1 sets their remote control unit to one side without switching it or the helicopter on

• Pilot 2 switches their remote control unit on and selects channel B

• Pilot 2 switches their helicopter on. Once it is ready, the pilot taps the actuating regulator briey,

whereby the helicopter sets itself to channel B.

• Pilot 2 sets their remote control unit to one side without switching it or the helicopter on

• Pilot 3 switches their remote control unit on and selects channel C

•

Pilo

t 3 switches their helicopter on. Once it is ready, the pilot taps the actuating regulator briey,

whereby the helicopter sets itself to channel C.

Now you can y the helicopters at the same time!



1. Take a Phillips screwdriver and

carefully unscrew the screws on

the rotor blade.

If the helicopter rotor blades are damaged and you have to replace them, proceed as follows:

Ensure before installation

that you have not mixed

up the rotor blades. The

rotor blades are marked

“A” and”B” (see Fig.)

Type “A” rotor blades are

installed on the top and

type “B” rotor blades are

installed below.

2.

No

w carefully pull the rotor

blade off the holder.

3.

Inser

t the new rotor blade carefully into the

holder and tighten the screw.

Caution: Do not screw in the screw too tightly.

The rotor blade must have some play.

Service guidelines















www.revell-control.de

English

Derecelendirme

Bu kılavuz hakkında daha fazla bilgi

Revell set 24040 Tiger Radyo-kontrol helikopter cihazınız için basılı bir kılavuza sahip olmanın güzel bir şey olduğunun farkındayız. Kılavuzu her zaman web sitemizden indirebilir ve kendiniz yazdırabilirsiniz. Orijinal bir kılavuza sahip olmak istiyorsanız Revell ile iletişime geçmenizi öneririz. Orijinal bir kılavuz sağlayabilirler. Revell set 24040 Tiger Radyo-kontrol helikopter cihazınızın kılavuzunu farklı bir dilde mi arıyorsunuz? Ana sayfamızdan tercih ettiğiniz dili seçin ve mevcut olup olmadığını görmek için model numarasını arayın.

Özellikler

Revell Radyo-kontrol helikopterler için tüm kılavuzlar
Revell ile ilgili daha fazla kılavuz

Revell set 24040 Tiger Radyo-kontrol helikopter hakkında Sıkça Sorulan Sorular

Destek ekibimiz faydalı ürün bilgileri arar ve sıkça sorulan soruları cevaplar. Sıkça sorulan sorularda hatalı bir cevaba rastlamanız halinde lütfen bunu iletişim formunu kullanarak bize bildirin.

İlgili ürünler

Kullanım kılavuzu

Revell set 24036 Hornet Radyo-kontrol helikopter

Kullanım kılavuzu

Revell set 24061 Cardinal Radyo-kontrol helikopter

Kullanım kılavuzu

Revell set 24042 Black Shadow Radyo-kontrol helikopter

Kullanım kılavuzu

Revell set 24084 Micro Heli Prion Radyo-kontrol helikopter

Kullanım kılavuzu

Revell set 24048 X-Razor Radyo-kontrol helikopter

Kullanım kılavuzu

Revell set 24067 Moovee Radyo-kontrol helikopter

Kullanım kılavuzu

Revell set 24083 Micro Heli Petrel Radyo-kontrol helikopter

Kullanım kılavuzu

Revell set 24041 Sparky Radyo-kontrol helikopter

İlgili kategoriler